by megabite | Nov 9, 2021
Objective NPT Avoidance and optimization using DrillTronics while drilling 17 ½” section. Solution DrillTronics implementation Results Top drive stalled and driller picked up. Overpull stopped by DrillTronics during pickup. Value Stuck pipe...
by megabite | Nov 9, 2021
Objective NPT Avoidance and optimization using DrillTronics while tripping 8 ½” drilling assembly. Solution DrillTronics implementation Results The bit hit swarf in the casing. Hook load safety triggered before driller reacted when running in hole. Movement stopped by...
by megabite | Nov 9, 2021
Objective Investigate pack off NPT during 7” liner run. Lost hole section. Symptoms not identified by rig or RTOC Solution Customer requested ‘Blind Trial’ with Sekal DrillTronics to see if DrillTronics would have helped Results DrillTronics triggered 1st action 7...
by megabite | Nov 9, 2021
Objective Following clean up cycle at TD of 8 ½” section, due to limiting high PP at TD of section (1,18sg) optimization of tripping is required Solution Drilltronics dynamic surge / swab protection was in use from section TD until surface to optimize tripping speed....